Clap Switch Project
In this project, I have explained how to make a clap switch circuit using 4017 IC. With this clap switch, you can turn on or turn off any device with the clap.
How does a clap switch work?
- At first, the clap sound sensed by the condenser mic.
- The condenser mic converts the sound into an electric pulse.
- Then the electric pulse amplified by the BC547 transistor.
- After that, the electrical pulse fed to the CLK pin of CD4017 IC.
- For each high pulse at CLK pin the state of the PIN 2 changes.
- When the PIN 2 becomes HIGH, the second transistor turns ON.
- If the second transistor turns ON the Relay also turns ON.
- Now when the condenser sense the second clap sound, the next high pulse received at CLK PIN.
- The PIN 2 changed the state (becomes LOW), so the second transistor turns OFF.
- So the Relay turns OFF and the load connected with the relay also turns OFF.
Required Components:
- CD4017 IC -1no
- BC547 NPN transistors -2no
- DC Condensor Mic -1no
- 100nf (103) Capacitor -2no
- 10k Resistors -2no
- 270k Resistor -1no
- 1M Resistor -1no
- 220-ohm Resistors -2no
- 1N4007 Diode -1no
- LED 5mm 3volt -1no
- 5v SPDT Relay
- AC Lamp 220v/110v
- 5v DC supply
- Breadboard or PCB
WhatsApp us